Marijuana drying rules
-To stop the photosynthesis and stop the plant to transpire because of heat and lightning, put the marijuana plants in a dark area.
-The plant ‘thinks’ it’s still alive if the juices still circulate. So make sure you hang them upside down.
-The plant will use its chlorophyll as a last energy resource because the roots can’t absorb any water and the leaves get no light. All this energy goes to the flowers so the marijuana plant can reproduce.
-To get a good flavor, dry the plant very slowly so the plant will use all its chlorophyll and converts it into sugar. No fans or heaters.
-Keep the temperature between 17°C to 18°C, and the humidity between 60 to 70%, so the plant won´t dry too quickly.
Always treat your plant with the best care possible. The sticky resin will attach to anything so don´t touch the flowers and hang it upside down
After a few days, the marijuana plant will change and the leaves will be bent around the flowers. Some people remove the large leaves before they hang the plant to dry, because it is easier than when the plants are dry but it has some disadvantages as well
-The plant dries faster if the large leaves are removed because the plant has little mass and less chlorophyll. If the leaves are removed, the total mass of the plants is reduced, so that it dries more quickly.
-Any moisture will evaporate through the leaves which reduces the risk of mold on the flowers, so leave them on.
- The leaves also form a sort of protection for the flowers because the bent around them.
After two weeks the leaves are dry but the flowers and the stem should still be flexible and sticky. The resin falls of easily so handle the plants with care. When the flowers turn to powder when crushed and the stems are brittles, the marijuana is too dry. Just check on your weed every few days. If the flower is sticky and the stem inside it cracks when bended, the marijuana plant is ready. It should have a fruity, mild flavor.
If the final product tastes bitter, then the marijuana was dried too quickly and did not have the time to perform all the necessary transformations. The drying room should be well-aired to prevent mold, but the room may not be ventilated, because otherwise the flowers will dry too quickly. A cupboard or storage unit is suitable for this. No cellars (too damp) or attics (too changeable).
A dehumidifier can be used, but this drying method is too fast. But sometimes, if the dry room is too moist, a dehumidifier can be a perfect solution. Also if the drying process has to be accelerated its better than using a heater. Check your plants on mold every day. If there is any mold, use a dehumidifier or a heater to speed up the drying process. Make sure the plants are not touching each other and cut large flowers into smaller pieces and put them on a sieve and let it dry.
Thanks for reading and good luck harvesting your marijuana. Please like, share or comment the article. And if you have any questions about growing marijuana go to our forum or contact me at firstname.lastname@example.org. Don’t forget to visit my webshop for high quality marijuana seeds.